Dynamic San Marino 2-person Low EMF FAR Infrared Sauna

Compact, quiet, and low-EMF, the Dynamic San Marino 2-Person FAR Infrared Sauna is built from natural reforested Canadian Hemlock and warmed by six low-EMF carbon heaters. Clear tempered glass and a chromotherapy system (with a dedicated Red-Light feature) create a bright, relaxing cabin you can plug into a standard 120V household outlet. Bluetooth/MP3 audio and dual LED control panels round out a premium at-home sweat experience.

Highlights

• 2-person indoor FAR infrared sauna (low EMF, 5–10 mG measured 2–3" from panels)

 

• 6 carbon heaters: 2 rear, 1 on each side, 1 under the bench, 1 in the floorboard

 

• Canadian Hemlock construction with clear tempered-glass door & side window

 

• Chromotherapy color lighting + Red-Light Therapy feature

 

• Dual LED control panels (interior/exterior)

 

• Bluetooth + MP3 aux with built-in speakers

 

• Heats best at 118–132°F (max up to ~140°F)

 

• 120V / 15A, non-GFCI plug-and-play (dedicated outlet recommended)

 

• Curbside LTL delivery; indoor use only

Specifications

• Model: Dynamic San Marino 2-Person Low EMF FAR Infrared Sauna

 

• Capacity: 2 adults

 

• Wood: Natural reforested Canadian Hemlock

 

• Heating system: 6 Dynamic low-EMF FAR infrared carbon panels (5–10 mG @ 2–3")

 

• Operating range: 118–132°F (up to ~140°F)

 

• Electrical: 120V / 15A, non-GFCI; plug-and-play (use a dedicated circuit where possible)

 

• Assembled dimensions: 42" L x 47" W x 75" H (roof overhang adds ~2" to length)

 

• Product weight: ~320 lb

 

• Glass: Clear tempered door with side window

 

• Location: Indoor only

 

Shipping (LTL, curbside):

• Carton A: ~238 lb — ~11" L x 48" W x 73" H

• Carton B: ~93 lb — ~9" L x 42" W x 47" H

• Pallet (LTL): ~20" L x 74" W x 54" H; ~375 lb total

Controls, Lighting, & Audio

• Dual LED control panels (inside & outside) for time, temp, lights, and audio

 

• One-touch start/stop; auto-timer with audible end-of-session alert

 

• Chromotherapy color lighting with dedicated Red-Light Therapy mode

 

• Bluetooth streaming + 3.5mm MP3 aux; integrated stereo speakers

 

• Interior reading light

What’s Included

• Pre-assembled wall panels with all heater elements installed

 

• Clear tempered-glass door & side window

 

• Bench, floor heater board, and interior mat

 

• Hardware pack & illustrated assembly guide

 

• Power cord (120V)

 

• Owner’s quick-start & safety sheet

Installation

1. Power: 120V / 15A non-GFCI outlet (dedicated circuit strongly recommended). Do not use extension cords.

2. Space: Place on a flat, dry, indoor surface. Leave ~2–3" clearance behind/sides for airflow and assembly.

3. Assembly: Two adults recommended. Panels interlock; connect labeled heater leads; hang the door; plug in. Typical setup 60–90 minutes.

4. Placement: Keep away from sprinklers, tubs/showers, and direct sunlight or HVAC vents.

5. Initial burn-in: Run one empty 30–45 min cycle at 130–140°F with door slightly open for ventilation.

FAQs

Is the EMF really low?

Yes—panels are rated about 5–10 mG measured 2–3 inches from the surface, dramatically lower than old ceramic elements.

 

What outlet do I need?

A standard 120V / 15A household outlet. Use non-GFCI and avoid extension cords. A dedicated circuit is best.

 

How hot will it get?

Ideal operating range is 118–132°F for consistent infrared absorption; cabin can reach up to ~140°F depending on room conditions.

 

Can I install it in a garage or bathroom?

Indoor, dry locations only. Avoid damp rooms, outdoor spaces, or areas subject to temperature swings or moisture.

 

How many heaters and where are they?

Six total: 2 rear, 1 each side, 1 under the bench, 1 in the floorboard for even, 360° coverage.

 

Does it have red-light therapy?

Yes. The chromotherapy system includes a Red-Light Therapy mode for targeted illumination.